Metal-sales Clip-Loc Installation User Manual download pdf (Page 10)

812.246.1935 (Corporate Ofﬁ ce) • www.mtlsales.us.com

CLIP-LOC

CAUTION

Improper loading and unloading of bundles and crates may result in bodily harm and/or

material damage. Metal Sales is not responsible for bodily injuries and/or material

damages resulting from improper loading and unloading.

It is the responsibility of the installer to unload material from the delivery truck. The installer shall be responsible for providing

suitable equipment for unloading of material from the delivery.

After receiving material, check the condition of the material, and review the shipment against the shipping list to ensure all mate-

rials are accounted for. If damages or shortages are discovered, it should be noted on the Bill of Lading at the time of delivery. A

claim should be made against the carrier as soon as possible. Metal Sales is not responsible for any damages or shortages unless

they are documented in writing and presented to Metal Sales within 48 hours.

Each bundle should be handled carefully to avoid being damaged. Care should be taken to prevent bending of the panel or abra-

sion to finish. Whenever possible, the bundle should remain crated until it is located in its place of storage. If bundles must be

opened, we recommend you recrate them before lifting. To avoid damage please lift the bundle at its center of gravity.

Forklift - A forklift may be used for panels up to 20'-0" long. Please make sure the forks are at their maximum separation. Do

not transport open bundles. When transporting bundles across rough terrain, or over a longer distance, some means of sup-

porting the panel load must be used.

Crane - A crane should be used when lifting panels with lengths greater than 20'-0". Please be sure to utilize a spreader bar to

ensure the even distribution of the weight to the pick up points. As a rule when lifting panels, no more than

of the length of

the panel should be left unsupported. Never use wire rope because this will damage the panels.

HANDLING MATERIAL

RECEIVING MATERIAL

GENERAL HANDLING

MECHANICAL HANDLING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

No comments

Metal-sales Clip-Loc Installation User Manual Page 10